Emergency buttons to trigger Panic, Fire and Medical alarms (simply press and hold for 3 seconds).New Keypad buttons and LEDs provide tactile and visual cues.Smaller, improved design makes it easier to mount and use.Don’t use inside detached garages, warehouses or sheds.Don’t use it outdoors or in environments with extreme hot or cold temperatures.You may want to install an additional Keypad in an upstairs bedroom or basement family room, for convenient arming and disarming.Install your Keypad near entry points - the doors you use most often to come and go. You can rest the Keypad on a flat surface or install it on a wall with the bracket and screws provided.Choose a convenient location so you can arm and disarm easily as you come and go.Follow the in-app instructions to complete setup.In the Ring app, tap Menu, then tap Set Up a Device, then tap Security Devices, then tap Keypads, and tap Keypad.Keep out of the reach of small children (who may play with the keypad).Alarm devices should always be used in the same building as the Base Station. Once your Keypad is set up, you will be prompted to create a four-digit Owner’s Access Code, using your App. Note: If you're planning to use the Keypad unplugged, you should fully charge it first.Īrming and disarming using your Ring Alarm KeypadĬlick here to learn more about arming and disarming your Ring Alarm Keypad. Later, if you ever want to change or Reset your Access Code: In the Ring app, open the menu. Make sure you’re on the right Location, then tap Location Settings. Definitely strange but hopefully this is enough info for you to work with. Let me know what I can do to help debug this. Once it is disarmed or armed manually the keypad does not work until it is once again manually changed to what it was before. Once again, the keypad does not like it when something other than a code is entered to either disarm or arm. Not until I manually opened the door which by rule disarmed the keypad would the keypad once again arm/disarm. This is to keep the keypad disarm/arm in sync with the door being open/closed.ĭuring testing, when I manually closed the door, the keypad changed to armed (like it should by the rule) but then the keypad would no longer work to disarm the system. The rule also includes logic that if the door is manually closed that it Arms the keypad, and if it is manually opened that is unarms the keypad. Since this is going to run a garage door, I have a rule: I checked the log and there is no errors. Not until I manually unarmed it from the device page would the keypad once again arm/disarm and it worked consistantly.īasically the keypad does not like it when something else arms or disarms it other than a code being entered. Once I did that, the keypad would no longer unarm it. The keypad codes were arming/disarming consistently up until I manually armed it within the device page. I decided to exclude the device and re-include it to see if it would make a difference. Not immediately sure why that didn't work. If I go into the events it shows the successful code being entered by the 'lastCodeName' field changing and then in 2 thousandths of a second the 'armingin' event occuring. Press 'disarmed' button if it is armed.Press either 'arm away' or 'arm home' button if it is disarmed.I can change the state by going into the device itself and clicking on the different states but nothing happens when I use the keypad to enter my 4 digit code. The issue I am having is the codes I entered are not changing the 'securityKeypad' state from armed to disarmed. The keypad is only going to be used to open/close a garage door with a Rule Used lock code manager to successfully add a couple of codes to the keypad.I am running the new 2.2.6 software released yesterday. I just purchased this Ring Keypad and for the first time installed it this afternoon.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |